This is the new APM 2.8 module. The sensors are exactly the same as with APM2.6, this version is ideal for use with multi-copters and rovers. The APM 2.8 is a complete open source autopilot system and the bestselling technology on the prestigious 2012 Outback Challenge UAV competition.
It allow..
This is the new APM 2.8 Flight Controller autopilot module. The sensors are exactly the same as with APM2.6, this version is ideal for use with multi-copters and rovers. The APM 2.8 is a complete open source autopilot system and the bestselling technology that on the prestigious 2012 Outback Challen..
The kk 2.1.5 flight controller is next big evolution of the first generation KK flight controller boards. The KK2.1.5 was engineered from the ground up to bring multi-rotor flight to everyone, not just the experts. The LCD screen and built in software makes install and setup easier than ever. A host..
CC3D Flight Controller Hardware Features
Powerful STM32 32-bit microcontroller running at 90MIPs with 128KB Flash and 20KB RAM.
3-axis high-performance MEMs gyros and 3-axis high-performance MEMs accelerometer.
Tiny 36mmx36mm 4 layer PCB for superior electrical noise reduction and flight performa..
X-Racer F303 V3.1 Flight Controller is designed for racers and acro pilots. This board still comes with the through-holes for Vbat, RSSI, and the buzzer. It also comes with dedicated SBUS and RGB LED connections. This X-Racer flight controller only comes in one version...ACRO!
Features:
E..
A3 V2 Flight Controller Gyro is the advanced version of the A3-L gyro with an integrated high precision 6-axis (3 Gyro + 3 accelerometers) MEMS sensor. The main advantage of a 6-axis gyro is that it will provide smooth and stable flight in less than ideal flying conditions, and it will also return y..
Ardupilot APM 2.8 Flight Controller with Built-in Compass is an amazing flight controller that allows the user to turn any fixed-wing, rotary-wing, or multi-rotor vehicle into a fully autonomous vehicle, capable of performing a wide range of tasks, even programmed GPS missions with waypoints.
The..
Cyclone 900RX 915MHZ ELRS Radio Nano Long Range Receiver is an open-source program based on esp8285. The receiver uses a low latency and high refresh rate RF chip with a high refresh rate of 25Hz-500Hz, which is very suitable for FPV competitions and remote FPV.
Features:
Frequency Band: 9..
DJI Naza m lite is the High-quality controller board for the drone (multirotor) by DJI brand. DJI is famous for its production of Drone. The stability that the DJI products is providing is very High stability. You can use this flight controller to make multirotor like tri-copter, quad-copter +, Quad..
DJI NAZA-M V2 Multirotor Autopilot Controller set With GPS Supports nine multi-rotor configurations, the DJI NAZA-M V2 Multirotor Autopilot Controller set With GPS acts as the brains of the aircraft, managing pilot input and interpreting data from the various sensors, helping maintain a stable flyin..
Naza-M Lite is the high reliability and stabilized flight controller by DJI. which have various features that make flight controller better than other.
Features:
All-in-One Design
Multiple flight control mode/intelligent switching
Support Futaba S-Bus and PPM receiver
GPS Module Avail..
ExpressLRS RX24T 2.4G Receiver is an open-source program based on ExpressLRS. The receiver uses a low latency and high refresh rate RF chip with a high refresh rate of 25Hz-500Hz, which is very suitable for FPV competitions and remote FPV.
Features:
Model: RX24T
Ultra-light and ultra-sma..