Top Brand
-7 %
Out Of Stock
Brand: DYS
Model: FR-02-541
Description:
This is a 30A ESC, Multi-copter Brushless Motor Speed Controller with a running current of 30A. The power input uses extreme low output resistance greatly enhances the power stability and has a protective effect on the battery. Separately voltage regulator IC ..
₹980 ₹1,059
-16 %
Brand: FlyRobo
Model: FR-02-830
P1-GYRO is based on the A3 three-axis stabilization, the flight control, switch control mode, and the three-axis lock (AVCS) mode is added. This mode uses the angle vector control algorithm to offset the angle of the aircraft around the three motion axes.
Features:
Real-time detection and c..
₹1,181 ₹1,399
Brand: FlyRobo
Model: FR-02-544
PDB-XT60 has been engineered to provide the highest possible performance and reliability in a 36x50mm & 4 layers PCB. It distributes power from a LiPo pack to 6 ESCs, as well as providing synchronized & regulated DC 5V outputs & linear regulated DC 12V for powering Cameras, Servos, RC receivers, Fli..
₹439
-34 %
Brand: FlyRobo
Model: FR-07-060
Pitot tube for the Arduplane Airspeed Sensor for pixhawk, APM 2.5 and 2.6
Package Includes:-
1 X Pitot Tube..
₹394 ₹599
Out Of Stock
Brand: FlyRobo
Model: FR-02-596
Pixhawk 0.96inch OLED Onboard Display Module is suitable for Pixhawk flight controller and can be useful for displaying a small amount of vehicle information before takeoff.
This information includes on Display:
Arming failure messages
Flight mode
Battery voltage
GPS Lock and satellit..
₹699
-30 %
Brand: FlyRobo
Model: FR-02-804
Characteristics:
Compatible with Alexmos2.2 or firmware below, compatible with the newest firmware BruGi_050 German, standard Russian2.2 firmwareTips
A new generation of strong input control 32-bit processor, a circuit board with PX4FMU + PX4IO
(Download Mission Planner HERE)
Specifi..
₹9,505 ₹13,599
Out Of Stock
Brand: FlyRobo
Model: FR-02-644
Specifications and Features:
Package Weight: 5 gm
Number of Ports: 5.
Board Dimensions: 33 x 12 x 6 mm(LxWxH)
Net Weight: 3g
Brand new and high quality
The I2C splitter expands the I2C port to allow up to four additional peripherals to connect to Pixhawk.
Use the 4-wire cable to c..
₹180
Out Of Stock
Brand: FlyRobo
Model: FR-02-565
The Mavlink LED Controller includes a controller board, 6 sets of highlight LED strips and one USB to UART module. It is compatible with any flight controller with ardupilot or PX4 firmware like Pixhawk serial, APM serial, Pixracer, NAVIO2, PXFmini, etc. It is compatible with Mavlink 1 and Mavlink 2..
₹1,899
-26 %
Brand: FlyRobo
Model: FR-02-547
Pixhawk Passive Buzzer has a two-position JST-SH connector on one side that plugs directly into the Pixhawk. Once connected you will be able to hear different sounds that relate to different modes!
This also includes the PX4 safety switch to enable you to arm/disarm your board at a moment's notic..
₹441 ₹599
-27 %
Brand: FlyRobo
Model: FRC-02-805
Features:
1. The advanced 32-bit ARM CortexM4 high-performance processors can run NuttX RTOS real-time operating system;
2. 14 PWM / servo output;
3. Bus interface (UART, I2C, SPI, CAN);
4. The integrated backup power and backup controller fails, the primary controller fails over to the bac..
₹11,555 ₹15,799
Brand: FlyRobo
Model: FR-02-558
This is a 30cm replacement GPS/Compass Connection Cable for modules like the Ublox M8N. It comes with a 6P connector for use with the Pixhawk . It is suitable for Pixhawk PX4 Flight Controller.
Package Includes:
1 x Pixhawk PX4 Flight Controller GPS Connection Cable 6 Pin
..
₹299
-11 %
Brand: FlyRobo
Model: FR-02-550
This includes an external RGB-LED and USB receptacle to connect to Pixhawk. Use the provided cables and connect to the I2C splitter module to set up a bright, multicolor LED and convenient USB port for your vehicle.
Features:
RGB indicator extends to outside displaying
Extension USB inter..
₹699 ₹789
