WH148 20K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 20K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
WH148 50K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 50K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
WH148 5K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 5K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
This is White Noise Signal Generator DIY Kit, with 2 channel signal output. It includes the common electronic components such as a resistor, capacitor, and potentiometer with DIP soldering mounting to practice your soldering skills
Features:
Easy to assemble
Two-way signal output
Perf..
Wireless 433MHz Garage Door Remote Control 4 buttons for 4 different garage doors, electronic rolling doors, or RF 433MHz retractable doors.
It is widely used in remote control switches, receiving modules, motorcycles, automobile anti-theft products, family anti-theft products, electric doors, ro..
This is WS2812 RGB LED Controller Adapter Module for ESP8266 ESP-01. You can make a colorful display project for Arduino IDE.
Features:
Interface: 3Pin connector.
Support 3.7V lithium battery.
It is based on ESP-01/ ESP-01S.
It supports Arduino IDE programming.
Package includes:
..
This is WXD3-13-2W 10K ohm Precision Potentiometer, widely used to adjust the timer, speed, and temperature.
Features:
Model: WXD3-13-2W
Small size, easy to carry
Provide full protection from dust, shock, scratches and bumps, and other daily damage.
Package Includes:
1 x WXD3-13..
This is WXD3-13-2W 4.7K ohm Precision Potentiometer, widely used to adjust the timer, speed, and temperature.
Features:
Model: WXD3-13-2W
Small size, easy to carry
Provide full protection from dust, shock, scratches and bumps, and other daily damage.
Package Includes:
1 x WXD3-1..
X9C103S DC 3-5V Digital Potentiometer Board Module for Arduino consists of a resistor array, wiper switches, a control section, and non-volatile memory. The wiper position is controlled by a three-wire interface. These are digitally controlled (XDCP) potentiometers.
The potentiometer is implemen..
This is the XBee Pro S2B module from Digi. The new Series 2B improves upon the power output and data protocol of the Pro Series2. Series 2B modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication betwee..
XBee S2C is an RF module designed for wireless communication or data exchange and it works on ZigBee mesh communication protocols that sit on top of IEEE 802.15.4 PHY. The module provides wireless connectivity to end-point devices in any ZigBee mesh networks including devices from other vendors. Ple..
XH-A232 30W + 30W TPA3110 Digital Stereo Audio Power Amplifier is a newly designed digital audio amplifier board with a dual-channel and also has a good performance. It features a high-efficiency class D audio power amplifier with the latest and original TPA3110 core technology the BTL bridge circui..