W25Q64 is a 64M-Bit Serial Flash memory that provides a storage solution for systems with limited space, pins, and power.
W25Q64 is a large capacity FLASH storage module SPI interface BV FV STM32 code. 25Q series that offers flexibility and performance well beyond ordinary Serial Flash devices..
The W5500 is a full-featured TCP/IP embedded Ethernet controller that provides an easier Internet connection solution for embedded systems.
The hardware logic gates are used to implement the transport layer and network layer of the TCP/IP protocol stack (eg TCP). , UDP, ICMP, IPv4, ARP, IGMP, PPP..
Water Sensor water level sensor is an easy-to-use, cost-effective high level/drop recognition sensor, which is obtained by having a series of parallel wires exposed traces measured droplets/water volume in order to determine the water level.
Very Easy to monitor water level as the output to an an..
This Ultrasonic Distance Sensor is an industrial-grade sensor to measure distance. Interfacing with it is the same as another cheap ultrasonic sensor, but it offers better performance and is compatible with harsher environments, and is waterproof too! It can be easily interfaced with Arduino and Sam..
WCS1700 Hall Current Sensor gives economical and precise solutions for both DC and AC current sensing in industrial, commercial, and communications systems. It has a low-temperature drift linear hall sensor IC with a temperature compensation circuit and diameter of 9.0mm through-hole. The hole will ..
An ESP8266 WiFi-based board with the Arduino layout and a 3.3V operational voltage is called the WeMos D1. The board features more flash memory than an Arduino Uno and is controlled by an ESP8266 chip, a 32-bit processor. It has 1 analog (input) pin and 11 digital I/O pins. A Micro-B USB cable can b..
WH148 100K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 100K ohm 3pin 15mm shaft potentiometer.
Package Includes:..
WH148 10K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 10K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
WH148 20K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 20K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
WH148 50K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 50K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
WH148 5K Ohm 3Pin 15mm Shaft Potentiometer is used for adjusting various parameters like voltage, current, etc in an electronic circuit. This is a three-terminal variable resistor that is used to vary or change the resistance.
It is a 5K ohm 3pin 15mm shaft potentiometer.
Package Includes:
..
This is White Noise Signal Generator DIY Kit, with 2 channel signal output. It includes the common electronic components such as a resistor, capacitor, and potentiometer with DIP soldering mounting to practice your soldering skills
Features:
Easy to assemble
Two-way signal output
Perf..