The DC 6V/300RPM N20 Metal Gear Motor, model GA12-N20, is a compact and powerful motor designed for various applications. With its high torque and low noise operation, this motor delivers reliable performance. The sturdy metal gears ensure durability and efficient power transmission. Operating at 6 ..
This is U Shape Fixed Mounting Bracket fits the mini 775 motors as a bracket or holder. It adopts an electroplating process and has a good anti-rust effect.
Features:
Type: U Shape Bracket
Center bench hole: the diameter is about 17.5mm
Vertical plane: 3mm thick, 52mm high, 50mm wide.
..
91T Spur Gear Differential Gear with 17T 19T 21T Pinions Gear Set is for 1/10 Arrma senton 4X4 550 gear, Typhon 4X4 550 gear, Granite 4X4 550 gear. It also includes 3 different pinion gears i.e. 21T, 19T, and 17T to make a choice in gear ratio. The speed depends on the gear ratio.
Features:
..
A3967 Stepper Motor Driver Board provides greater flexibility and control over the stepper motor. This stepper motor driver is compatible with most microcontrollers that can output a digital 0 to 5V pulse.
Features:
Easy to interface with Arduino
Adjustable current control.
A3967 micro..
A4950 Dual Motor Driver Module can control the positive and negative rotation of 2 motors.
Features:
Module with current limit protection
4 PWM pins are required(If you do not need to reverse, only 2 PWM pins are needed).
It is much simpler to use than the L298 and provides instructions..
Specification:
If jumper is hit the position of ON DP, that means 16 segment (4988) or 32 segment (8825)Jm connected motor
connect 5v and 9v power supply
E, S, D, G, respectively corresponding to the connection of the Enable/Step/Dir/Gnd drive signal output
Package included:
1 ..
The A4988 driver Stepper Motor Driver is a complete micro-stepping motor driver with a built-in converter, easy to operate. It operates from 8 V to 35 V and can deliver up to approximately 1 A per phase without a heat sink or forced air flow (it is rated for 2 A per coil with sufficient additional c..
Aluminum 15T Arm use with EMAX ES08MA II servo for 1/24 scale Axial SCX24 RC crawler Jeep. It is perfect for servos with 15 teeth and has an aluminum body.
Features:
Teeth Number: 15T
Color: Red
High-quality and durable in performance.
Lightweight and portable to carry
It has an alu..
Aluminum Servo Horn Arm 25T compatible with MG995 servo motor. It includes two steel bolts to secure the split clamp onto servo output. It is perfect for servos with 25 teeth and has an aluminum body.
Features:
Teeth Number: 25T
Color: Red
High-quality and durable in performance.
Ligh..
Aluminum Servo Horn Arm 25T compatible with MG995 servo motor. It includes two steel bolts to secure the split clamp onto servo output. It is perfect for servos with 25 teeth and has an aluminum body.
Features:
Teeth Number: 25T
Color: Silver
High-quality and durable in performance.
L..
Aluminum Servo Horn 25T is the round type used in a variety of applications. The Aluminum Servo Horn 25T Round type is made up of quality aluminum and is designed to work with MG995 Servo Motors.
Features:
Color: Blue
High-quality Aluminum
Disc Type Metal Horns for 25T MG995 MG996
..