Brand: FlyRobo
Model: FR-01-738
AM2302 Humicap digital temperature and humidity module is a digital output signal containing a calibrated temperature and humidity combined sensor.
It uses dedicated digital modules capture technology and the temperature and humidity sensor technology to ensure that products with high reliabilit..
₹115 ₹349
Brand: FlyRobo
Model: FR-01-729
DS18B20 Temperature Sensor Module is a Digital temperature sensor DS18B20 that will tell you temperature with 9 to 12-bit resolution! Uses only 1 wire to the Arduino or other microcontroller for communication. With the One Wire protocol, you can operate a large number of these sensors from one Ardui..
₹65 ₹129
Brand: FlyRobo
Model: FR-01-966
The MAX31865 is an easy-to-use thermistor to digital output converter optimized for platinum resistance temperature detectors (RTD). The external resistor sets the RTD sensitivity, and the high-precision Δ- ΣADC converts the RTD resistor and the reference resistor to digital output. The MAX31865 inp..
₹440 ₹1599
Brand: FlyRobo
Model: FR-01-826
NTC Thermistor Module is a temperature sensor module that senses the temperature of the surrounding environment by the thermistor and converts it into a digital and analog output. The thermistor is the short form of thermal resistance and its resistance increases and decreases in the proportion of t..
₹34 ₹58
Brand: FlyRobo
Model: FR-01-830
AM2301/DHT21 Temperature & Humidity Sensor is one of the commonest from the range of DHT temperature sensors and boasts a relatively high-temperature measurement accuracy of 0.5°C in 0.1°C steps with a relative humidity accuracy of ± 3%.
It has only 3 wires, including power and ground, meaning on..
₹318 ₹469
Brand: FlyRobo
Model: FR-01-806
It is a high-speed I2C interface temperature sensor. In the temperature range of -55 ℃ ~ + 125 ℃, the temperature was directly converted to digital signals, and to achieve the accuracy of 0.125 ℃. MCU can read data of its internal registers directly via the I2C bus and can operate four registers thr..
₹85 ₹189
Brand: FlyRobo
Model: FR-01-829
The DHT11 Temperature And Humidity Sensor Module with LED is a small humidity and temperature sensor that you can connect to your Arduino and get readings for temperature and humidity in the environment. DHT11 can be interface with any microcontroller like Arduino, Raspberry Pi, etc., and get instan..
₹63 ₹139
Brand: FlyRobo
Model: FR-01-868
The DS18B20 Digital Thermometer provides 12-bit centigrade temperature measurements and has an alarm function with nonvolatile user-programmable upper and lower trigger points.
The DS18B20 communicates over a 1-wire bus that by definition requires only one data line (and ground) for communicatio..
₹22 ₹89
Brand: FlyRobo
Model: FR-01-617
DS18B20 Waterproof Digital Temperature Sensor cable is very useful to measure temperature far away or in wet conditions. While the sensor is good up to 125°C the cable is jacketed in PVC so we suggest keeping it under 100°C.
They work great with any microcontroller using a single digital pin, and..
₹54 ₹139
Brand: FlyRobo
Model: FRC-01-780
This gas sensor kit includes a total of 9 Gas sensor.
MQ-135 Air Quality & Hazardous Gas Sensor Module
MQ-2 Smoke Methane Gas & Liquefied Flammable Gas Sensor Module
MQ-3 Alcohol Ethanol Gas Sensor Module
MQ-4 Methane Gas Sensor Module
MQ-5 Liquefied Gas & Coal Gas Sensor Module
MQ-6..
₹969 ₹1199
Brand: FlyRobo
Model: FR-01-885
KY-013 Analog Temperature Module is based on the thermistor (resistance increases with the ambient temperature changes) which sense the real-time temperature of the surrounding environment changes. Change in temperature data in analog form can be taken from this module on analog IO pins, then throug..
₹38 ₹49
Brand: FlyRobo
Model: FR-01-827
LM35 is an integrated analog temperature sensor whose electrical output is proportional to Degree Centigrade. LM35 Sensor does not require any external calibration or trimming to provide typical accuracies. The LM35’s low output impedance, linear output, and precise inherent calibration make interfa..
₹77